Welcome Baby Card Made With a Little Bit of Everything

So tonight I set out to make a baby card. I wasn't sure exactly what it was going to look like, but I knew I wanted a Monkey on it. So using card stock, patterned paper, ribbon, a circuit cartridge and a little imagination here is the end result. Nothing fancy but I like it and I hope you do too. Below is a supply list and sizing for the pieces.




Measurements and brief instructions:

Monkey and Vine: Cut at 3" There are three
layers to the monkey. The base is black card stock, next layer is kraft paper and the top layer is brown cardstock. The edges of the top layer are inked brown.

Card: 5 1/2 x 4 1/4' when folded

Ribbon: 8" with a knot tied at the end and then edges cut off
Patterned Paper: 5 1/2" x 3"


Supplies (with link to where they can be purchased):

Colonial White Card Stock
BoBunny Hello Sunshine Collection
Create a Critter: Cricut Cartridge
Twilight Ribbon from CTMH: (no longer available)
Brown, Kraft, Black and Olive Cardstock
CTMH My Acrylix Stamp Set: Glamour Lower Case Alphabets D1522
CTMH Exclusive Ink Pads- Sunset, Olive, Crème Brulee and Twilight
My Acrylix Clear Block 1x 3 1/2"
 

Happy Paper Crafting!